Unable to get Signal

[LizQuilty]

Starting a new thread since this appears to be a new issue

I have the latest version of the firmware on the phone. When i power it up, it boots up, gets to the menu screen, then reboots right away.
The second boot , it stays going, but its not getting any signal and connecting. I have a youtube video showing the issue https://www.youtube.com/watch?v=d299Yrqv_gI

If i attach it to the PC and its in Debug mode then it shows the following

I have checked and re-attached the GSM module with no luck. Any ideas?

[LizQuilty]

Nobody? anyone?

[angusgr]

Hi Liz,

Sorry for the delay in getting back to you.

That kind of gibberish is usually a sign of a baud rate mismatch. The computer is listening at a different rate to the rate that the ArduPhone is outputting data.

Try changing the baud rate in the serial monitor from 9600 to 38400. The "usbserial.ino" part of the sketch has the call to Serial.begin() that sets the baud rate to 38400.

Some recent Arduino IDEs (1.5.x I think) don't have 38400 as an option any more, in which case the easiest thing to do is to change the value in usbserial.ino to Serial.begin(9600) or 19200.

- Angus