Arduino IDE 1.0.1: programmer is out of sync

The EtherTen combines an Uno-equivalent Arduino-compatible board and Wiznet-based Ethernet support, along with a microSD card slot and Power-over-Ethernet support. [Product page]
Post Reply
Sleurhutje
Posts:28
Joined:Thu Mar 01, 2012 9:18 am
Arduino IDE 1.0.1: programmer is out of sync

Post by Sleurhutje » Fri May 25, 2012 7:26 am

If installed the new Arduino IDE 1.0.1 to test the several bug fixes. However, the result is that I'm not able to upload the compiled sketch to the EtherTen anymore. Besides the board settings for the Arduino UNO I've tried all other board types, each of them resulting in the same or a different error (the latter due to incompatible hardware of course). If I compile and upload the sketch with Arduino IDE 1.0 all works fine. :(
Binary sketch size: 29.154 bytes (of a 32.256 byte maximum)

avrdude: stk500_paged_write(): (a) protocol error, expect=0x14, resp=0xe0
avrdude: stk500_cmd(): programmer is out of sync

hads
Posts:10
Joined:Tue May 01, 2012 3:58 am

Re: Arduino IDE 1.0.1: programmer is out of sync

Post by hads » Fri May 25, 2012 8:38 am

I've just uploaded a test sketch to the EtherTen with Arduino 1.0.1 and it seems to work fine here.

Sleurhutje
Posts:28
Joined:Thu Mar 01, 2012 9:18 am

Re: Arduino IDE 1.0.1: programmer is out of sync

Post by Sleurhutje » Fri May 25, 2012 10:01 am

It looks like the maximum size of the compiled sketch is less in 1.0.1. About 1200 bytes less and all works fine. However,my predefined texts are no more availbale in the sketch and has become useless.

:(

Post Reply