Does anybody know why the leostick does not show up in my Tools > Serial Port list until after the sketch has loaded?
Haven't plugged this leostick into a computer in a long time. When I plug it into USB it goes straight to the Sketch (I think) because the blue LED comes on and then the other LED goes bright green straight away. There is no "breathing red" when initially plugging it in.
If I press the reset button while plugged into USB it will breath red for a few seconds, but during this breathing the leostick does not show up in the Tools > Serial Port list. Once the LED goes bright green (Sketch starts?) the Tools > Serial Port list shows the leostick, and the serial monitor outputs a series of 0's once a second (probably some debugging from previous sketch).
When trying to upload I get this error:
Code: Select all
Binary sketch size: 4,320 bytes (of a 28,672 byte maximum) Found programmer: Id = "0000000"; type = 0 Software Version = 0.0; Hardware Version = 0.0 avrdude: error: buffered memory access not supported. Maybe it isn't a butterfly/AVR109 but a AVR910 device?
This also results in a bunch of dead avrdude processes on this linux laptop. Have tried Arduino IDE 1.0.1 and 1.0.4 and the suggestions in the other hung sketch threads.
Is there some magic "reset to factory defaults" method for the leostick?