I followed all the instructions on the freetronics site when I first got my Leostick and
I installed the sample blink program, Ok
Then I put it away.
Somewhere along the line I rebuilt my PC.
Then I tried to use my leostick again but had trouble because The driver is not installed.
And the stick came up as
deviceInstance ID = USB\VID_2341&PID_0034&MI_00\...... etc
Windows doesnt recognise "FreetronicsUSB_V10.inf"
But I searched around and found in the following folder
Which is where I extracted the arduino software
I opened it using wordpad
and added a third device to the [DeviceList]
Then ran device manager again and updated the driver pointing to this new file.
The device immediately became visible. and available in Arduino 1.0.3
I am now able to compile and load sketches again directly to the leostick.
I dont know what I will do if the sketch freezes as mentioned for a locked up sketch.
Because I havent figured out how to install the usb driver for the boot loader section
that is recognised as ="Freetronics LeoStick"
I'm guessing it wont be there long enough to use the driver update function in device manager.
Any suggestions on how to load a driver for a device that isn't there?
For when this event does occur.
A shrunk down Leonardo-compatible board, thumb drive sized with native USB support. [Product info]
1 post • Page 1 of 1