DMD2 with STM32F1/4
The Dot Matrix Display (DMD) is a 32x16 array of high-brightness LEDs for visually striking effects. [Product Page]
-
- Posts:1
- Joined:Fri Nov 10, 2017 1:16 am
Post by figoarzaki » Fri Nov 10, 2017 1:48 am
did there are any people that have try using dmd library stm32f1/f4?, if so can you please share your experience?
Return to “Dot Matrix Display”
Jump to
- Arduino-Compatible Boards
- ↳ ArduPhone
- ↳ CNCPlotter
- ↳ Eleven
- ↳ EtherDue
- ↳ EtherMega
- ↳ EtherTen
- ↳ Goldilocks
- ↳ KitTen
- ↳ LeoStick
- ↳ LeoStick examples, software and fun sketches
- ↳ Pebble v2
- ↳ StepDuino
- ↳ USBDroid
- Arduino Expansion Shields
- ↳ BTSH: Bluetooth Shield
- ↳ DLOCK: RFID Door Lock Shield
- ↳ ES: Ethernet Shield
- ↳ HBRIDGE: H-Bridge Motor Driver Shield
- ↳ LCDK: LCD & Keypad Shield
- ↳ RX315/RX433: 315MHz and 433MHz Receiver Shields
- ↳ SECSENSE: Security Sensor Shield
- ↳ SH-RFIDLOCK: RFID Lock Shield
- ↳ SBS: SimpleBot Shield
- ↳ THINK: Thinker Shield
- ↳ TS: Terminal Shield
- Modules, Sensors, & Displays
- ↳ Module Discussion
- ↳ Dot Matrix Display
- ↳ Experimenters Kit
- ↳ 4x4x4 RGB Cube
- ↳ OLED128 Display
- Raspberry Pi
- ↳ Raspberry Pi Expansion Boards
- ArduSat Arduino Satellite
- ↳ General ArduSat Discussion
- ↳ ArduSat Payload Processor Module
- General Discussion
- ↳ Random Chit-Chat
- ↳ Project Showcase
- ↳ Product / Device Ideas
- ↳ Practical Arduino
- ↳ Arduino Workshop
- ↳ 3D Printing
- ↳ SuperHouseTV Home Automation
- Arduino Shield List
- ↳ Shield Discussion
- ↳ Shield List Site Discussion