How to connect 16x32 LED display

The Dot Matrix Display (DMD) is a 32x16 array of high-brightness LEDs for visually striking effects. [Product Page]
Post Reply
UTNU7TUYTUY
Posts: 1
Joined: Thu May 09, 2019 9:12 am

How to connect 16x32 LED display

Post by UTNU7TUYTUY » Thu May 09, 2019 9:16 am

MatrixCable.jpg
Hello sir
How to connect 16x32 LED display to card there are 8 pin and 8 pin total 16 pin

UNO_ONU
Posts: 3
Joined: Sun Jul 14, 2019 4:17 am

Re: How to connect 16x32 LED display

Post by UNO_ONU » Sun Jul 14, 2019 10:52 am

The diagram shows where the pins connect to the Arduino, e.g. OE to Digital pin 9, A to Digital pin 6, B to Digital pin 7, etc.
It just left out that pins 5, 7, 9, 13 and 15 are also GND the same as pin 3. Just join them all together.
Pins 6, 14 and 16 are not used or needed.

They are for a Mono Colour Panel only, if you want to use an RGB Panel, the wiring is completely different.

Post Reply